Reference Guide

Table 29. Battery (continued)
Property Description
provide high level and detailed health status of the ManagedElement and its
subcomponents.
Possible values are:
● 0 = Unknown—Indicates the implementation is in general capable of returning
this property, but is unable to do so at this time.
● 1 = OK—Indicates the ManagedElement is functioning normally.
● 2 = Degraded—Indicates the ManagedElement is functioning below normal.
● 3 = Error—Indicates the ManagedElement is in an Error condition.
● .. = DMTF Reserved
●
0x8000.. = Vendor Reserved
RemainingCapacityMaxError
The maximum error (as a percentage) in the mWatt-hour data reported by
RemainingCapacity property.
RequestedState
An integer enumeration that indicates the last requested or desired state for the
element, irrespective of the mechanism through which it was requested. The actual
state of the element is represented by EnabledState. This property is provided to
compare the last requested and current enabled or disabled states.
Possible values are:
● 0 = Unknown—Indicates the last requested state for the element is unknown.
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change
● 6 = Offline—Indicates that the element has been requested to transition to the
Enabled but Offline EnabledState.
● 7 = Test
● 8 = Deferred
● 9 = Quiesce
● 10 = Reboot—Refers to doing a Shut Down and then moving to an Enabled
state.
● 11 = Reset—Indicates that the element is first Disabled and then Enabled.
● 12 = Not Applicable
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
NOTE: When EnabledState is set to 5 (Not Applicable), then this property has
no meaning. Refer to the EnabledState property description for explanations of
the values in the RequestedState enumeration.
NOTE: The value No Change (5) has been deprecated instead of indicating the
last requested state is Unknown (0). If the last requested or desired state is
unknown, RequestedState should have the value Unknown (0), but may have
the value No Change (5).
There are two new values in RequestedState that build on the statuses of
EnabledState. These are Reboot (10) and Reset (11).
Shut Down requests an orderly transition to the Disabled state, and may involve
removing power, to completely erase any existing state. The Disabled state requests
an immediate disabling of the element, such that it will not execute or accept any
commands or processing requests.
This property is set as the result of a method invocation (such as Start or
StopService on CIM_Service), or can be overridden and defined as WRITEable in a
subclass. The method approach is considered superior to a WRITEable property,
because it allows an explicit invocation of the operation and the return of a result
code.
Dell Command | Monitor 10.4 classes and properties
111