Reference Guide

Table 28. PowerSupply (continued)
Property Description
● 0 = Unknown—Indicates that the last requested state for the element is
unknown.
● 2 = Enabled—Indicates that the element is or could be executing commands, will
process any queued commands, and queues new requests.
● 3 = Disabled—Requests an immediate disabling of the element, such that it will
not run or accept any commands or processing requests.
● 4 = Shut Down—Requests an orderly transition to the Disabled state, and may
involve removing power, to completely erase any existing state.
● 5 = No Change
● 6 = Offline—Indicates that the element has been requested to transition to the
Enabled but Offline EnabledState.
● 7 = Test
● 8 = Deferred
● 9 = Quiesce
● 10 = Reboot—Refers to doing a Shut Down and then moving to an Enabled
state.
● 11 = Reset—Indicates that the element is first Disabled and then Enabled.
● 12 = Not Applicable
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
The actual state of the element is represented by EnabledState. This property is
provided to compare the last requested and current enabled or disabled states. Note
that when EnabledState is set to 5 (Not Applicable), then this property has no
meaning. Refer to the EnabledState property description for explanations of the
values in the RequestedState enumeration.
NOTE:
The value No Change (5) has been deprecated instead of indicating the
last requested state is Unknown (0). If the last requested or desired state is
unknown, RequestedState should have the value Unknown (0), but may have
the value No Change (5).
There are two new values in RequestedState that build on the statuses of
EnabledState. These are Reboot (10) and Reset (11). This property is set as the
result of a method invocation (such as Start or StopService on CIM_Service), or can
be overridden and defined as WRITEable in a subclass. The method approach is
considered superior to a WRITEable property, because it allows an explicit invocation
of the operation and the return of a result code.
If knowledge of the last RequestedState is not supported for the
EnabledLogicalElement, the property is NULL or has the value 12 Not Applicable.
SystemCreationClassName
The CreationClassName of the scoping system.
SystemName
The System Name of the scoping system.
TotalOutputPower
Represents the total output power of the PowerSupply in milli Watts. 0 denotes
unknown.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
● 0 = Unknown
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change—Indicates that no transition is in progress.
● 6 = Offline
● 7 = Test
106 Dell Command | Monitor 10.4 classes and properties