Reference Guide

Table 23. Memory (continued)
Property Description
● 12 = No Contact—Indicates that the monitoring system
has knowledge of this element, but has never been able to
establish communications with it.
● 13 = Lost Communication—Indicates that the
ManagedSystem Element is known to exist and has
been contacted successfully in the past, but is currently
unreachable.
● 14 = Aborted
● 15 = Dormant—Indicates that the element is inactive or
quiesced.
● 16 = Supporting Entity in Error—Indicates that this
element may be OK but that another element, on which
it is dependent, is in error. An example is a network
service or endpoint that cannot function due to lower-
layer networking problems.
● 17 = Completed—Indicates that the element has
completed its operation. This value should be combined
with either OK, Error, or Degraded so that a client
can tell if the complete operation Completed with OK
(passed), Completed with Error (failed), or Completed
with Degraded (the operation finished, but it did not
complete OK or did not report an error).
●
18 = Power Mode—Indicates that the element has
additional power model information contained in the
Associated PowerManagementService association.
● .. = DMTF Reserved
● 0x8000.. = Vendor Reserved
OperationalStatus replaces the Status property on
ManagedSystemElement to provide a consistent approach
to enumerations, to address implementation needs for an
array property, and to provide a migration path from today's
environment to the future. This change was not made
earlier because it required the deprecated qualifier. Due
to the widespread use of the existing Status property in
management applications, it is strongly recommended that
providers or instrumentation provide both the Status and
OperationalStatus properties. Further, the first value of
OperationalStatus should contain the primary status for the
element. When instrumented, Status (because it is single-
valued) should also provide the primary status of the element.
OtherIdentifyingInfo
Captures data, in addition to DeviceID information, that could
be used to identify a LogicalDevice. For example, you could
use this property to hold the operating system's user-friendly
name for the Device.
PrimaryStatus Provides a high level status value, intended to align with
Red-Yellow-Green type representation of status. It should be
used in conjunction with DetailedStatus to provide high level
and detailed health status of the ManagedElement and its
subcomponents. Possible values are:
● 0 = Unknown—Indicates the implementation is in general
capable of returning this property, but is unable to do so at
this time.
● 1 = OK—Indicates the ManagedElement is functioning
normally.
● 2 = Degraded—Indicates the ManagedElement is
functioning below normal.
● 3 = Error—Indicates the ManagedElement is in an Error
condition.
84 Dell Command | Monitor 10.5 classes and properties