Reference Guide

Table 9. EthernetPort (continued)
Property Description
NOTE: The value No Change (5) has been deprecated instead of indicating the last
requested state is Unknown (0). If the last requested or desired state is unknown,
RequestedState should have the value Unknown (0), but may have the value No
Change (5). There are two new values in RequestedState that build on the statuses
of EnabledState. These are Reboot (10) and Reset (11). Shut Down requests an orderly
transition to the Disabled state, and may involve removing power, to completely erase
any existing state. The Disabled state requests an immediate disabling of the element,
such that it will not execute or accept any commands or processing requests. This
property is set as the result of a method invocation (such as Start or StopService on
CIM_Service), or can be overridden and defined as WRITEable in a subclass. The method
approach is considered superior to a WRITEable property, because it allows an explicit
invocation of the operation and the return of a result code. If knowledge of the last
RequestedState is not supported for the EnabledLogicalElement, the property is NULL
or has the value 12 Not Applicable. Possible values are:
● 0 = Unknown
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change
● 6 = Offline—Indicates that the element has been requested to transition to the Enabled
but Offline EnabledState.
● 7 = Test
● 8 = Deferred
● 9 = Quiesce
● 10 = Reboot—Refers to performing a Shut Down and then moving to an Enabled state.
● 11 = Reset—Indicates that the element is first Disabled and then Enabled.
● 12 = Not Applicable
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
SystemCreationClassName
The creation classname of the scoping system.
SystemName The system name of the scoping system.
TOEEnabledState An integer enumeration that indicates the enabled and disabled states of the TOE. Possible
values are:
● 0 = Unknown
● 1 = Other
● 2 = Enabled—Indicates that the TOE is enabled and running.
● 3 = Disabled—Indicates that the TOE is disabled.
● 4 = Not Applicable—Indicates that the ethernet port does not have TOE capability.
● 5..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
TransitioningToState Indicates the target state to which the instance is transitioning. Possible values are:
● 0 = Unknown
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change—Indicates that no transition is in progress.
● 6 = Offline
● 7 = Test
● 8 = Defer
● 9 = Quiesce
●
10 = Reboot
● 11 = Reset
46 Dell Command | Monitor 10.5 classes and properties