Reference Guide

Table 7. DesktopMonitor (continued)
Property Description
OperationalStatus replaces the Status property on
ManagedSystemElement to provide a consistent approach
to enumerations, to address implementation needs for an
array property, and to provide a migration path from
today's environment to the future. This change was
not made earlier because it required the deprecated
qualifier. Due to the widespread use of the existing Status
property in management applications, it is recommended
that providers or instrumentation provide both the Status
and OperationalStatus properties. Further, the first value of
OperationalStatus should contain the primary status for the
element. When instrumented, Status (because it is single-
valued) should also provide the primary status of the element.
PhysicalSizeH Horizontal screen size in cm.
PhysicalSizeV Vertical screen size in cm.
PrimaryStatus Provides a high-level status value, intended to align with
Red-Yellow-Green type representation of status. It should be
used with DetailedStatus to provide high level and detailed
health status of the ManagedElement and its subcomponents.
PrimaryStatus consists of one of the following values:
● 0 = Unknown—Indicates that the implementation is in
general capable of returning this property, but is unable
to do so now
● 1 = OK—Indicates the ManagedElement is functioning
normally.
● 2 = Degraded—Indicates the ManagedElement is
functioning below normal.
● 3 = Error—Indicates the ManagedElement is in an Error
condition.
● .. = DMTF Reserved
● 0x8000.. = Vendor Reserved
ProductCode Product code of this monitor.
RequestedState An integer enumeration that indicates the last requested or
desired state for the element, irrespective of the mechanism
through which it was requested. The actual state of the
element is represented by EnabledState. This property is
provided to compare the last requested and current enabled
or disabled states. When EnabledState is set to 5 (Not
Applicable), then this property has no meaning. Refer to
the EnabledState property description for explanations of the
values in the RequestedState enumeration. Unknown (0)
indicates that the last requested state for the element is
unknown.
NOTE: The value No Change (5) has been deprecated
instead of indicating the last requested state is Unknown
(0). If the last requested or desired state is unknown,
RequestedState should have the value Unknown (0), but
may have the value No Change (5).Offline (6) indicates
that the element has been requested to transition to the
Enabled but Offline EnabledState. There are two new
values in RequestedState that build on the statuses of
EnabledState. These are Reboot (10) and Reset (11).
Shut Down requests an orderly transition to the Disabled
state, and may involve removing power, to completely
erase any existing state. The Disabled state requests an
34 Dell Command | Monitor 10.5 classes and properties