Reference Guide

Table 7. DesktopMonitor (continued)
Property Description
● 8 = Deferred—Indicates that the element may be
completing commands, but queues any new requests.
● 9 = Quiesce—Indicates that the element is enabled but in
a restricted mode.
● 10 = Starting—Indicates that the element is in the process
of going to an Enabled state. New requests are queued.
● 11..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
FrequencyH This property is a horizontal synchronization signal frequency
in Hz as determined by the display.
FrequencyV This property is a vertical synchronization signal frequency in
Hz as determined by the display.
HealthState Indicates the current health of the element. This attribute
expresses the health of this element but not necessarily that
of its subcomponents. Possible values are:
● 0 = Unknown—The implementation cannot report on
HealthState now. DMTF has reserved the unused portion
of the continuum for additional HealthStates in the future.
● 5 = OK—The element is fully functional and is operating
within normal operational parameters and without error.
● 10 = Degraded/Warning—The element is in working order
and all functionality is provided. However, the element is
not working to the best of its abilities. For example, the
element may not be operating at optimal performance or it
may be reporting recoverable errors.
● 15 = Minor failure—All functionality is available but some
may be degraded.
● 20 = Major failure—The element is failing. It is possible
that some or all of the functionality of this component is
degraded or not working.
● 25 = Critical failure—The element is nonfunctional and
recovery may not be possible.
● 30 = Non-recoverable error—The element has failed, and
recovery is not possible. All functionality provided by this
element has been lost.
● .. = DMTF Reserved
IdentifyingDescriptions
An array of free-form strings providing explanations and
details behind the entries in the OtherIdentifyingInfo array.
Each entry of this array is related to the entry in
OtherIdentifyingInfo that is located at the same index.
InputAnalog Input is an analog video signal interface.
InputDigital Input is a digital video signal interface.
InputDisplayPort DisplayPort is supported.
InputDVI DVI is supported.
InputHDMI HDMI is supported.
InputSource An enumerated value identifying the current input source.
Writing a new value into this property changes the device's
input source to the specified value, if the value is supported
as specified in InputSourceCapabilities. If the requested value
is not in InputSourceCapabilities, then the current value of
InputSource is unchanged. Possible values are:
● 0 = Unknown
Dell Command | Monitor 10.5 classes and properties 31