Reference Guide

Table Of Contents
Table 150. BIOS settings supported in Dell Command | Monitor 10.5 (continued)
BIOS Settings Name Description Supported
Operating
System(s)
FX100 BIOS Access
Allows or blocks the remote user to access BIOS Setup via
FX100 Portal.
Possible values are:
On
Off
Windows
General Purpose Encryption Enables or Disables the general purpose encryption (GPE)
on the system.
Possible values are:
Enabled
Disabled
Windows
GPS Antenna Switch This setting configures on a radio-by-radio basis and
determines which antenna to be used when the system is
docked. This is applicable for docking station or the system.
If the default value is set to Dock antenna, then the radio
uses the external docking station antenna. If the default
value is set to System, then the radio uses the internal
system antenna. When the system is undocked, then the
system antennas are in use.
NOTE: This setting applies to Rugged docking stations
and does not apply to USB Type-C docking stations.
Possible values are:
Dock Antenna
System Antenna
Windows, Linux
GPS on WWAN Radio Enables or Disables GPS WWAN Radio.
Possible values are:
Enabled
Disabled
Windows, Linux
GPS Radio Enables or Disables the internal GPS radio.
Possible values are:
Enabled
Disabled
Windows, Linux
Hard Disk Acoustic Mode Sets the Hard Disk Acoustic Mode.
Possible values are:
Bypass
Quiet
Suggested
Performance
Windows
Hard-Disk Failover Specifies which devices in the Hard-Disk Drive Sequence
menu are attempted in the boot sequence. When set to
OFF, only the first device in the list is attempted. When set
to ON, all devices are attempted in order, as listed in the
Hard-Disk Drive Sequence.
Possible values are:
Disabled
Enabled
Windows
Hardware Prefetcher Enables or Disables the CPUs HW prefetcher. Windows, Linux
BIOS settings supported in Dell Command | Monitor 10.5 263