Reference Guide

Table 132. ElementSettingData (continued)
Property Description
IsNext An enumerated integer indicating whether or not the referenced setting is the
next setting to be applied. For example, the application could take place on a re-
initialization, reset, reconfiguration request. This could be a permanent setting, or
a setting used only one time, as indicated by the flag. If it is a permanent setting
then the setting is applied every time the managed element reinitializes, until this flag
is manually reset. However, if it is single use, then the flag is automatically cleared
after the settings are applied. Also note that if this flag is specified (i.e. set to value
other than Unknown), then this takes precedence over any SettingData that may
have been specified as Default. For example: If the managed element is a computer
system, and the value of this flag is Is Next, then the setting will be effective next
time the system resets. And, unless this flag is changed, it will persist for subsequent
system resets. However, if this flag is set to Is Next For Single Use, then this
setting will only be used once and the flag would be reset after that to Is Not Next.
So, in the above example, if the system reboots in a quick succession, the setting will
not be used at the second reboot. Possible values are:
● 0 = Unknown
● 1 = Is Next
● 2 = Is Not Next
● 3 = Is Next For Single Use
IsPending An enumerated integer that indicates whether or not the referenced
CIM_SettingData instance represents outstanding changes to the configuration of
the referenced CIM_ManagedElement that are known to be pending and are in the
process of being applied. A value of 0 Unknown indicates that the referenced
instance of CIM_SettingData may represent the last configuration applied to
the referenced CIM_ManagedElement. A value of 2 (Is Pending) indicates that
the referenced instance of CIM_SettingData represents outstanding changes to
the configuration of the referenced CIM_ManagedElement that are known to be
pending. A value of 3 (Is Not Pending) indicates that the referenced instance of
CIM_SettingData does not represent outstanding changes to the configuration of
the referenced CIM_ManagedElement.Possible values are:
● 0 = Unknown
● 2 = Is Pending
● 3 = Is Not Pending
● .. = DMTF Reserved
● 32768.. = Vendor Reserved
ManagedElement The managed element.
SettingData The SettingData object that is associated with the element.
DCIM_OrderedMemberOfCollection
Table 133. OrderedMemberOfCollection
Property Description
AssignedSequence AssignedSequence is an unsigned integer n that indicates the relative position of
members within a Collection. When n is a positive integer, it indicates a place in
the sequence of members, with smaller integers indicating earlier positions in the
sequence. The special value 0 indicates don't care. If two or more members have
the same non-zero sequence number, then the ordering between those members
is irrelevant, but they must all be ordered at the appropriate place in the overall
sequence. A series of examples will make ordering of members clearer: If all members
have the same sequence number, regardless of whether it is 0 or non-zero, any
order is acceptable. The values are: 1:MEMBER A 2:MEMBER B 1:MEMBER C
3:MEMBER D indicate two acceptable orders: A,C,B,D or C,A,B,D, because A and
C can be ordered in either sequence, but only at the 1 position.
232 Dell Command | Monitor 10.5 classes and properties