Reference Guide

Table 2. ApplicationProxySetting (continued)
Property Description
● A return code of 0 indicates the proxy settings that were
updated successfully.
● A return code of 1 indicates the proxy settings that were
not updated successfully.
DCIM_BaseMetricDefinition
Table 3. BaseMetricDefinition
Property Description
Caption The Caption property is a short textual description (one- line string) of
the object.
Description The Description property provides a textual description of the object.
ElementName A user-friendly name for the object. This property allows each instance
to define a user-friendly name in addition to its key properties, identity
data, and description information.
NOTE: The Name property of ManagedSystemElement is also
defined as a user-friendly name. But, it is often subclassed to be
a Key. It is not reasonable that the same property can convey
both identity and a user-friendly name, without inconsistencies.
Where Name exists and is not a Key (such as for instances of
LogicalDevice), the same information can be present in both the
Name and ElementName properties.
Accuracy Indicates the accuracy of the values reported for this metric.
AccuracyUnits The accuracy is expressed as the value of theAccuracy property in the
units specified by the AccuracyUnits property.
BreakdownDimensions Defines one or more strings that can be used to refine (break down)
queries against the BaseMetricValues along a certain dimension. An
example is a transaction name, allowing the break down of the total
value for all transactions into a set of values, one for each transaction
name. Other examples might be application system or user group name.
The strings are free format and should be meaningful to the end users of
the metric data. The strings indicate which break down dimensions are
supported for this metric definition, by the underlying instrumentation.
Calculable An enumerated value that describes the characteristics of the metric,
for purposes of performing calculations. Possible values are:
● 1 = Non-calculable
● 2 = Summable
● 3 = Non-summable
ChangeType ChangeType indicates how the metric value changes, in the form of
typical combinations of finer grain attributes such as direction change,
minimum and maximum values, and wrapping semantics. Possible values
are:
● 0 = Unknown
● 2 = N/A
● 3 = Counter
● 4 = Gauge
● 5..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
● 3 = Counter
Dell Command | Monitor 10.5 classes and properties 19