Reference Guide

Table 47. ComputerSystem (continued)
Property Description
● 4 = Shut Down
● 5 = No Change—Indicates that no transition is in progress.
● 6 = Offline
● 7 = Test
● 8 = Defer
● 9 = Quiesce
● 10 = Reboot
● 11 = Reset
● 12 = Not Applicable—Indicates the implementation does not support representing
ongoing transitions
A value other than 5 or 12 identifies the state to which the element is in the process
of transitioning.
RequestStateChange (Method) Requests that the state of the element be changed to the value specified in the
RequestedState parameter. When the requested state change takes place, the
EnabledState and RequestedState of the element will be the same. Invoking the
RequestStateChange method multiple times could result in earlier requests being
overwritten or lost.
A return code of 0 shall indicate the state change was successfully initiated.
A return code of 3 shall indicate that the state transition cannot complete within the
interval specified by the TimeoutPeriod parameter.
A return code of 4096 (0x1000) shall indicate the state change was successfully
initiated, a ConcreteJob has been created, and its reference returned in the output
parameter Job. Any other return code indicates an error condition.
DCIM_RecordLog
Table 48. RecordLog
Property Description
ElementName ElementName A user-friendly name for the object. This property allows each instance
to define a user-friendly name in addition to its key properties, identity data, and
description information.
NOTE: The Name property of ManagedSystemElement is also defined as a user-
friendly name. But, it is often subclassed to be a Key. It is not reasonable that
the same property can convey both identity and a user-friendly name, without
inconsistencies. Where Name exists and is not a Key (such as for instances
of LogicalDevice), the same information can be present in both the Name and
ElementName properties.
EnabledDefault An enumerated value indicating an administrator's default or startup configuration for
the Enabled State of an element. Possible values are:
● 2 = Enabled
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState An integer enumeration that indicates the enabled and disabled states of an element.
It can also indicate the transitions between these requested states. For example,
166 Dell Command | Monitor 10.5 classes and properties