Reference Guide

Table 47. ComputerSystem (continued)
Property Description
● 19 = Bridge/Extender
● 20 = Gateway
● 21 = Storage Virtualizer
● 22 = Media Library
● 23 = ExtenderNode
● 24 = NAS Head
● 25 = Self-contained NAS
● 26 = UPS
● 27 = IP Phone
● 28 = Management Controller—Indicates this instance represents specialized
hardware dedicated to systems management (i.e., a Baseboard Management
Controller (BMC) or service processor).
● 29 = Chassis Manager—Indicates this instance represents a system dedicated
to management of a blade chassis and its contained devices. This value would
be used to represent a Shelf Controller. A Chassis Manager is an aggregation
point for management and may rely on subordinate management controllers for
the management of constituent parts.
● 30 = Host-based RAID controller—Indicates this instance represents a RAID
storage controller contained within a host computer.
● 31 = Storage Device Enclosure—Indicates this instance represents an enclosure
that contains storage devices.
● 32 = Desktop
● 33 = Laptop
● 34 = Virtual Tape Library—Is the emulation of a tape library by a Virtual Library
System.
● 35 = Virtual Library System—Uses disk storage to emulate tape libraries.
● 36..32567 = DMTF Reserved
● 32568..65535 = Vendor Reserved
ElementName
A user-friendly name for the object. This property allows each instance to define
a user-friendly name in addition to its key properties, identity data, and description
information.
NOTE: The Name property of ManagedSystemElement is also defined as a user-
friendly name. But, it is often subclassed to be a Key. It is not reasonable that
the same property can convey both identity and a user-friendly name, without
inconsistencies. Where Name exists and is not a Key (such as for instances
of LogicalDevice), the same information can be present in both the Name and
ElementName properties.
EnabledDefault An enumerated value indicating an administrator's default or startup configuration
for the Enabled State of an element.
Possible values are:
● 2 = Enabled
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState An integer enumeration that indicates the enabled and disabled states of an element.
It can also indicate the transitions between these requested states. For example,
shutting down (value = 4) and starting (value = 10) are transient states between
enabled and disabled.
162 Dell Command | Monitor 10.5 classes and properties