Reference Guide

Table 46. SoftwareInstallationService (continued)
Property Description
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState An integer enumeration that indicates the enabled and disabled states of an element.
It can also indicate the transitions between these requested states. For example,
shutting down (value = 4) and starting (value = 10) are transient states between
enabled and disabled.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Enabled—Indicates that the element is or could be executing commands, will
process any queued commands, and queues new requests.
● 3 = Disabled—Indicates that the element will not execute commands and will
drop any new requests.
● 4 = Shutting Down—Indicates that the element is in the process of going to a
Disabled state.
● 5 = Not Applicable—Indicates the element does not support being enabled or
disabled.
● 6 = Enabled but Offline—Indicates that the element may be completing
commands, and will drop any new requests.
● 7 = In Test—Indicates that the element is in a test state.
● 8 = Deferred—Indicates that the element may be completing commands, but will
queue any new requests.
● 9 = Quiesce—Indicates that the element is enabled but in a restricted mode.
● 10 = Starting—Indicates that the element is in the process of going to an
Enabled state. New requests are queued.
● 11..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
Name
The Name property uniquely identifies the Service and provides an indication of the
functionality that is managed. This functionality is described in more detail in the
Description property of the object.
PrimaryOwnerContact A string that provides information on how the primary owner of the Service can be
reached (for example, phone number, e-mail address, and so on).
PrimaryOwnerName The name of the primary owner for the service, if one is defined. The primary owner
is the initial support contact for the Service.
PrimaryStatus Provides a high level status value, intended to align with Red-Yellow-Green type
representation of status. It should be used in conjunction with DetailedStatus
to provide high level and detailed health status of the ManagedElement and its
subcomponents.
Possible values are:
● 0 = Unknown—Indicates the implementation is in general capable of returning
this property, but is unable to do so at this time.
● 1 = OK—Indicates the ManagedElement is functioning normally.
● 2 = Degraded—Indicates the ManagedElement is functioning below normal.
● 3 = Error—Indicates the ManagedElement is in an Error condition.
● .. = DMTF Reserved
● 0x8000.. = Vendor Reserved
RequestedState An integer enumeration that indicates the last requested or desired state for the
element, irrespective of the mechanism through which it was requested.
Dell Command | Monitor 10.5 classes and properties 159