Reference Guide

Table 37. NetworkPortConfigurationService (continued)
Property Description
Note that when EnabledState is set to 5 (Not Applicable), then this property has
no meaning. Refer to the EnabledState property description for explanations of the
values in the RequestedState enumeration.
NOTE: The value No Change (5) has been deprecated instead of indicating the
last requested state is Unknown (0). If the last requested or desired state is
unknown, RequestedState should have the value Unknown (0), but may have
the value No Change (5).
There are two new values in RequestedState that build on the statuses of
EnabledState. These are Reboot (10) and Reset (11).
Shut Down requests an orderly transition to the Disabled state, and may involve
removing power, to completely erase any existing state. The Disabled state requests
an immediate disabling of the element, such that it will not execute or accept any
commands or processing requests.
This property is set as the result of a method invocation (such as Start or
StopService on CIM_Service), or can be overridden and defined as WRITEable in
a subclass. The method approach is considered superior to a WRITEable property,
because it allows an explicit invocation of the operation and the return of a result
code.
If knowledge of the last RequestedState is not supported for the
EnabledLogicalElement, the property is NULL or has the value 12 (Not Applicable).
SystemCreationClassName The CreationClassName of the scoping System.
SystemName The Name of the scoping System.
TransitioningToState Indicates the target state to which the instance is transitioning.
Possible values are:
● 0 = Unknown
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change—Indicates that no transition is in progress.
● 6 = Offline
● 7 = Test
●
8 = Defer
● 9 = Quiesce
● 10 = Reboot
● 11 = Reset
● 12 = Not Applicable—Indicates that the implementation does not support
representing ongoing transitions
A value other than 5 or 12 identifies the state to which the element is in the process
of transitioning.
DCIM_TimeService
Table 38. TimeService
Property Description
CreationClassName Indicates the name of the class or the subclass that is used in the creation of an
instance. When used with the other key properties of this class, this property allows
all instances of this class and its subclasses to be uniquely identified.
Dell Command | Monitor 10.5 classes and properties 139