Reference Guide

Table 36. LCDPanel (continued)
Property Description
DisplayDataCategory Identifies the category of data to be displayed on the LCD Panel.
Possible values are:
● 2 = None
● 3 = User Specified
● 4 = Default
● 5 = IPv4 Address
● 6 = IDRAC MAC Address
● 7 = Service Tag
● 8 = System Name
●
9 = IPv6 Address
● 10 = Ambient
● 11 = System Power
DisplayModeUserString Contains a user configurable string to be displayed on the LCD panel if
DisplayDataCategory has the value 3.
EnabledDefault An enumerated value indicating an administrator's default or startup configuration
for the Enabled State of an element.
Possible values are:
● 2 = Enabled
● 3 = Disabled
● 5 = Not Applicable
● 6 = Enabled but Offline
● 7 = No Default
● 9 = Quiesce
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState An integer enumeration that indicates the enabled and disabled states of an element.
It can also indicate the transitions between these requested states.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Enabled—Indicates that the element is or could be executing commands, will
process any queued commands, and queues new requests.
● 3 = Disabled—Indicates that the element will not execute commands and will
drop any new requests.
● 4 = Shutting Down—Indicates that the element is in the process of going to a
Disabled state.
● 5 = Not Applicable—Indicates the element does not support being enabled or
disabled.
● 6 = Enabled but Offline—Indicates that the element may be completing
commands, and will drop any new requests.
● 7 = In Test—Indicates that the element is in a test state.
● 8 = Deferred—Indicates that the element may be completing commands, but will
queue any new requests.
● 9 = Quiesce—Indicates that the element is enabled but in a restricted mode.
● 10 = Starting—Indicates that the element is in the process of going to an
Enabled state. New requests are queued.
● 11..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
For example, shutting down (value = 4) and starting (value = 10) are transient states
between enabled and disabled.
136
Dell Command | Monitor 10.5 classes and properties