Reference Guide

Table 32. Sensor (continued)
Property Description
● 10 = Reboot
● 11 = Reset
● 12 = Not Applicable
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
SensorType The Type of the Sensor, e.g. Voltage or Temperature Sensor. If the type is set
to Other, then the OtherSensorType Description can be used to further identify
the type, or if the Sensor has numeric readings, then the type of the Sensor
can be implicitly determined by the Units. A description of the different Sensor
types is as follows: A Temperature Sensor measures the environmental temperature.
Voltage and Current Sensors measure electrical voltage and current readings. A
Tachometer measures speed/revolutions of a Device. For example, a Fan Device can
have an associated Tachometer which measures its speed. A Counter is a general
purpose Sensor that measures some numerical property of a Device. A Counter
value can be cleared, but it never decreases. A Switch Sensor has states like Open/
Close, On/Off, or Up/Down. A Lock has states of Locked/Unlocked. Humidity,
Smoke Detection and Air Flow Sensors measure the equivalent environmental
characteristics. A Presence Sensor detects the presence of a PhysicalElement. A
Power Consumption Sensor measures the instantaneous power consumed by a
managed element. A Power Production Sensor measures the instantaneous power
produced by a managed element such as a power supply or a voltage regulator. A
pressure sensor is used to report pressure. Intrusion sensor reports an intrusion of
an enclosure regardless whether it was authorized or not.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Temperature
● 3 = Voltage
● 4 = Current
● 5 = Tachometer
● 6 = Counter
● 7 = Switch
● 8 = Lock
● 9 = Humidity
● 10 = Smoke Detection
● 11 = Presence
● 12 = Air Flow
● 13 = Power Consumption
● 14 = Power Production
● 15 = Pressure
● 16 = Intrusion
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
SystemCreationClassName
The CreationClassName of the scoping system.
SystemName The System Name of the scoping system.
TransitioningToState Indicates the target state to which the instance is transitioning.
Possible values are:
● 0 = Unknown
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change—Indicates that no transition is in progress.
126 Dell Command | Monitor 10.5 classes and properties