Reference Guide

DCIM_NumericSensor
Table 31. NumericSensor
Property Description Supported
Operating
System(s)
BaseUnits The base unit of the values returned by this Sensor. All the values returned by
this Sensor are represented in the units obtained by (BaseUnits * 10 raised to the
power of the UnitModifier). For example, if BaseUnits is Volts and the UnitModifier
is -6, then the units of the values returned are MicroVolts. However, if the
RateUnits property is set to a value other than None, then the units are further
qualified as rate units. In the above example, if RateUnits is set to Per Second,
then the values returned by the Sensor are in MicroVolts/Second. The units apply
to all numeric properties of the Sensor, unless explicitly overridden by the Units
qualifier. Possible values are:
● 0 = Unknown
● 1 = Other
●
2 = Degrees C
● 3 = Degrees F
● 4 = Degrees K
● 5 = Volts
● 6 = Amps
● 7 = Watts
● 8 = Joules
● 9 = Coulombs
● 10 = VA
● 11 = Nits
● 12 = Lumens
● 13 = Lux
● 14 = Candelas
● 15 = kPa
● 16 = PSI
● 17 = Newtons
● 18 = CFM
● 19 = RPM
● 20 = Hertz
● 21 = Seconds
● 22 = Minutes
● 23 = Hours
● 24 = Days
● 25 = Weeks
● 26 = Mils
● 27 = Inches
● 28 = Feet
● 29 = Cubic Inches
● 30 = Cubic Feet
● 31 = Meters
● 32 = Cubic Centimeters
● 33 = Cubic Meters
● 34 = Liters
● 35 = Fluid Ounces
● 36 = Radians
● 37 = Steradians
● 38 = Revolutions
● 39 = Cycles
● 40 = Gravities
Windows, Linux
Dell Command | Monitor 10.5 classes and properties 115