Reference Guide

Table 29. Battery (continued)
Property Description
● 18 = Power Mode—Indicates that the element has additional power model
information contained in the Associated PowerManagementService association.
● .. = DMTF Reserved
● 0x8000.. = Vendor Reserved
OperationalStatus replaces the Status property on ManagedSystemElement to
provide a consistent approach to enumerations, to address implementation needs
for an array property, and to provide a migration path from today's environment to
the future. This change was not made earlier because it required the deprecated
qualifier. Due to the widespread use of the existing Status property in management
applications, it is strongly recommended that providers or instrumentation provide
both the Status and OperationalStatus properties. Further, the first value of
OperationalStatus should contain the primary status for the element. When
instrumented, Status (because it is single-valued) should also provide the primary
status of the element.
OtherIdentifyingInfo OtherIdentifyingInfo captures data, in addition to DeviceID information, that could be
used to identify a LogicalDevice. For example, you could use this property to hold the
operating system's user-friendly name for the Device.
Supported fields are Location and ePPID.
PrimaryStatus Provides a high level status value, intended to align with Red-Yellow-Green type
representation of status. It should be used in conjunction with DetailedStatus
to provide high level and detailed health status of the ManagedElement and its
subcomponents. Possible values are:
● 0 = Unknown—Indicates the implementation is in general capable of returning
this property, but is unable to do so at this time.
● 1 = OK—Indicates the ManagedElement is functioning normally.
● 2 = Degraded—Indicates the ManagedElement is functioning below normal.
● 3 = Error—Indicates the ManagedElement is in an Error condition.
● .. = DMTF Reserved
●
0x8000.. = Vendor Reserved
RemainingCapacityMaxError The maximum error (as a percentage) in the mWatt-hour data reported by
RemainingCapacity property.
RequestedState An integer enumeration that indicates the last requested or desired state for the
element, irrespective of the mechanism through which it was requested. The actual
state of the element is represented by EnabledState. This property is provided to
compare the last requested and current enabled or disabled states. Possible values
are:
● 0 = Unknown—Indicates the last requested state for the element is unknown.
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change
●
6 = Offline—Indicates that the element has been requested to transition to the
Enabled but Offline EnabledState.
● 7 = Test
● 8 = Deferred
● 9 = Quiesce
● 10 = Reboot—Refers to doing a Shut Down and then moving to an Enabled
state.
● 11 = Reset—Indicates that the element is first Disabled and then Enabled.
● 12 = Not Applicable
● .. = DMTF Reserved
● 32768..65535 = Vendor Reserved
104 Dell Command | Monitor 10.5 classes and properties