Install Guide

ManualsBrandsDell ManualsAnalyticsCommand | Monitor

Table Of Contents

Dell Command | Monitor Version 10.4 Installation Guide
Introduction to Dell Command | Monitor 10.4
- Supported Windows operating systems
- Downloading Dell Command | Monitor
System requirements for Dell Command | Monitor 10.4
Prerequisites for Dell Command | Monitor 10.4
- Prerequisites for systems running on Windows
- Prerequisites for systems running on Linux
  - Prerequisites for Dell Edge Gateway systems
Installing Dell Command | Monitor 10.4 for systems running on Windows
Installing Dell Command | Monitor 10.4 for systems running on Linux
Upgrading Dell Command | Monitor 10.4 for systems running on Windows
Upgrading Dell Command | Monitor 10.4 for systems running on Linux
Uninstalling Dell Command | Monitor 10.4 for systems running on Windows
Uninstalling Dell Command | Monitor 10.4 for systems running on Linux

Upgrading Dell Command | Monitor using Snap

package

To upgrade Dell Command | Monitor from a canonical store:

1. Log in to the Gateway system.

The default username and password is admin.

2. Run the following command:

snappy update dcm

Upgrading Dell Command | Monitor 10.4 for systems running on Linux 19