Install Guide
Table Of Contents
- Dell Command | Monitor Version 10.4 Installation Guide
- Introduction to Dell Command | Monitor 10.4
- System requirements for Dell Command | Monitor 10.4
- Prerequisites for Dell Command | Monitor 10.4
- Installing Dell Command | Monitor 10.4 for systems running on Windows
- Installing Dell Command | Monitor 10.4 for systems running on Linux
- Upgrading Dell Command | Monitor 10.4 for systems running on Windows
- Upgrading Dell Command | Monitor 10.4 for systems running on Linux
- Uninstalling Dell Command | Monitor 10.4 for systems running on Windows
- Uninstalling Dell Command | Monitor 10.4 for systems running on Linux
- Uninstalling Dell Command | Monitor using Deb Package
- Uninstalling Dell Command | Monitor using an RPM package
- Uninstalling Dell Command | Monitor version 9.1 and 9.1.2 from Dell Edge Gateway 5000 or 3000 series systems running Ubuntu Core 15.04 using Snap package
- Uninstalling Dell Command | Monitor from Dell Edge Gateway 3000 series systems running Ubuntu Core 16 using Snap package
Upgrading Dell Command | Monitor in CLI or silent
mode
You can upgrade from the previous version of Dell Command | Monitor using CLI without restarting the system.
Table 2. Commands used for upgrade
Operation Command
Upgrade from previous
version (major upgrade)
msiexec /i Command_Monitor_<x86 or x64>.msi REINSTALL=ALL
REINSTALLMODE=vmous /qn
To upgrade without reboot
msiexec /i Command_Monitor_<x86 or x64>.msi REINSTALL=ALL
REINSTALLMODE=vmous REBOOT=REALLYSUPPRESS /qn
Upgrading Dell Command | Monitor 10.4 for systems running on Windows 17