Install Guide
Table Of Contents
- Dell Command | Monitor Version 10.4 Installation Guide
- Introduction to Dell Command | Monitor 10.4
- System requirements for Dell Command | Monitor 10.4
- Prerequisites for Dell Command | Monitor 10.4
- Installing Dell Command | Monitor 10.4 for systems running on Windows
- Installing Dell Command | Monitor 10.4 for systems running on Linux
- Upgrading Dell Command | Monitor 10.4 for systems running on Windows
- Upgrading Dell Command | Monitor 10.4 for systems running on Linux
- Uninstalling Dell Command | Monitor 10.4 for systems running on Windows
- Uninstalling Dell Command | Monitor 10.4 for systems running on Linux
- Uninstalling Dell Command | Monitor using Deb Package
- Uninstalling Dell Command | Monitor using an RPM package
- Uninstalling Dell Command | Monitor version 9.1 and 9.1.2 from Dell Edge Gateway 5000 or 3000 series systems running Ubuntu Core 15.04 using Snap package
- Uninstalling Dell Command | Monitor from Dell Edge Gateway 3000 series systems running Ubuntu Core 16 using Snap package
5. To verify that the Dell Command | Monitor is installed in your system, run
rpm -qa | grep command-monitor-linux
If Dell Command | Monitor details are displayed, and then the installation is successful.
Installing Dell Command | Monitor on the systems
running Ubuntu Core 16 using Snap package
To install Dell Command | Monitor on systems running Ubuntu Core 16 from the Dell Canonical store using snap package:
1. Log in to the Gateway system.
The default username and password is admin
2. Run the following command:
snap install <your package name>.snap
Installing Dell Command | Monitor 10.4 for systems running on Linux 15