Reference Guide

Table 24. PCIDevice (continued)
Property Description
● 4 = Shutting Down — Indicates that the element is in the
process of going to a Disabled state.
● 5 = Not Applicable — Indicates the element does not
support being enabled or disabled.
● 6 = Enabled but Offline — Indicates that the element may
be completing commands, and will drop any new requests.
● 7 = In Test — Indicates that the element is in a test state.
● 8 = Deferred — Indicates that the element may be
completing commands, but will queue any new requests.
● 9 = Quiesce — Indicates that the element is enabled but in
a restricted mode.
● 10 = Starting — Indicates that the element is in the
process of going to an Enabled state. New requests are
queued.
● 11..32767 = DMTF Reserved
● 32768..65535 = Vendor Reserved
FunctionNumber
The function number for this PCI device.
HealthState
Indicates the current health of the element. This attribute
expresses the health of this element but not necessarily that
of its subcomponents.
Possible values are:
● 0 = Unknown — The implementation cannot report on
HealthState at this time. DMTF has reserved the unused
portion of the continuum for additional HealthStates in the
future.
● 5 = OK — The element is fully functional and is operating
within normal operational parameters and without error.
● 10 = Degraded/Warning — The element is in working
order and all functionality is provided. However, the
element is not working to the best of its abilities. For
example, the element may not be operating at optimal
performance or it may be reporting recoverable errors.
● 15 = Minor failure — All functionality is available but some
may be degraded.
● 20 = Major failure — The element is failing. It is possible
that some or all of the functionality of this component is
degraded or not working.
● 25 = Critical failure — The element is non-functional and
recovery may not be possible.
● 30 = Non-recoverable error — The element has
completely failed, and recovery is not possible. All
functionality provided by this element has been lost.
● .. = DMTF Reserved
StatusInfo
The use of this method is deprecated instead of a more clearly
named property (EnabledState) that is inherited from
ManagedSystemElement and that has additional enumerated
values. Deprecated description: The StatusInfo property
indicates whether the Logical Device is in an enabled state
(value = 3), disabled state (value = 4), some other state
(value = 1), or an unknown state (value = 2). If this property
does not apply to the LogicalDevice, the value 5 (Not
Applicable) should be used. If a Device is Enabled (value =
3), it has been powered up and is configured and operational.
The Device may or may not be functionally active, depending
Dell Command | Monitor 10.2.1 classes and properties 93