Reference Guide

Table 10. FlatPanel (continued)
Property Description
HorizontalResolution
The horizontal resolution in Pixels of the flat panel.
MaxQuiesceTime
The use of this property has been deprecated. When evaluating the use of Quiesce,
it was determined that this single property is not adequate for describing when a
device will automatically exit a quiescent state. In fact, the most likely scenario for a
device to exit a quiescent state was determined to be based on the number of
outstanding requests queued rather than on a maximum time. This decision will be
re-evaluated and repositioned later. Deprecated description: Maximum time, in
milliseconds, that a Device can run in a Quiesced state. The state is defined in its
Availability and Additional Availability properties, where Quiesced is conveyed by the
value 21. What occurs at the end of the time limit is device-specific. The Device can
unquiesce, can be offline, or can take other actions. A value of 0 indicates that a
Device can remain quiesced indefinitely.
ScanMode
The scan mode of a flat panel indicating either single (value = 2) or dual scan 3.
Possible values are:
● 0 = Unknown
● 1 = Other
● 2 = Single Scan
● 3 = Dual Scan
SystemCreationClassName
The creation class name of the scoping system.
SystemName
The system name of the scoping system.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
● 0 = Unknown
● 2 = Enabled
● 3 = Disabled
● 4 = Shut Down
● 5 = No Change — Indicates that no transition is in progress.
● 6 = Offline
● 7 = Test
●
8 = Defer
● 9 = Quiesce
● 10 = Reboot
● 11 = Reset
● 12 = Not Applicable — Indicates that the implementation does not support
representing ongoing transitions.
A value other than 5 or 12 identifies the state to which the element is in the process
of transitioning.
VerticalResolution
Vertical resolution in Pixels of a flat panel.
DCIM_IPProtocolEndpoint
Table 11. IPProtocolEndpoint
Property Description
AddressOrigin
Identifies the method by which the IP Address, Subnet Mask,
and Gateway were assigned to the IPProtocolEndpoint.
Possible values are:
50 Dell Command | Monitor 10.2.1 classes and properties