Reference Guide

Table 7. DesktopMonitor (continued)
Property Description
or endpoint that cannot function due to lower-layer
networking problems.
● 17 = Completed — Indicates that the element has
completed its operation. This value should be combined
with either OK, Error, or Degraded so that a client can tell
if the complete operation Completed with OK (passed),
Completed with Error (failed), or Completed with
Degraded (the operation finished, but it did not complete
OK or did not report an error).
● 18 = Power Mode — Indicates that the element has
additional power model information contained in the
Associated PowerManagementService association.
● .. = DMTF Reserved
● 0x8000.. = Vendor Reserved
OperationalStatus replaces the Status property on
ManagedSystemElement to provide a consistent approach to
enumerations, to address implementation needs for an array
property, and to provide a migration path from today's
environment to the future. This change was not made earlier
because it required the deprecated qualifier. Due to the
widespread use of the existing Status property in
management applications, it is recommended that providers or
instrumentation provide both the Status and
OperationalStatus properties. Further, the first value of
OperationalStatus should contain the primary status for the
element. When instrumented, Status (because it is single-
valued) should also provide the primary status of the element.
PhysicalSizeH
Horizontal screen size in cm.
PhysicalSizeV
Vertical screen size in cm.
PrimaryStatus
Provides a high-level status value, intended to align with Red-
Yellow-Green type representation of status. It should be used
with DetailedStatus to provide high level and detailed health
status of the ManagedElement and its subcomponents.
PrimaryStatus consists of one of the following values:
● 0 = Unknown — Indicates that the implementation is in
general capable of returning this property, but is unable to
do so now
● 1 = OK — Indicates the ManagedElement is functioning
normally.
● 2 = Degraded — Indicates the ManagedElement is
functioning below normal.
● 3 = Error — Indicates the ManagedElement is in an Error
condition.
● .. = DMTF Reserved
● 0x8000.. = Vendor Reserved
ProductCode
Product code of this monitor.
RequestedState
An integer enumeration that indicates the last requested or
desired state for the element, irrespective of the mechanism
through which it was requested. The actual state of the
element is represented by EnabledState. This property is
provided to compare the last requested and current enabled
or disabled states. When EnabledState is set to 5 (Not
Dell Command | Monitor 10.2.1 classes and properties 35