Reference Guide

Table 149. BIOS settings supported in Dell Command | Monitor 10.2.1 (continued)
BIOS Settings Name Description Supported
Operating
System(s)
● 1 — ADC Input — Sets the channel mode as Analog-to-
Digital Converter (ADC) input.
● 2 — DAC Output — Sets the channel mode as Digital-
to-Analog Converter (DAC) output.
● 3 — DAC and ADC — Sets the channel mode as DAC
output, but can be monitored through ADC input.
● 8 — GPIO — Sets the channel mode as General
Purpose Input or Output.
Analog Digital Interface Mode
Channel 6
Sets the defined Analog/Digital Interface mode for channel
6.
Possible values are:
● 0 — Unused — Channel is unused.
● 1 — ADC Input — Sets the channel mode as Analog-to-
Digital Converter (ADC) input.
● 2 — DAC Output — Sets the channel mode as Digital-
to-Analog Converter (DAC) output.
● 3 — DAC and ADC — Sets the channel mode as DAC
output, but can be monitored through ADC input.
● 8 — GPIO — Sets the channel mode as General
Purpose Input or Output.
Microsoft Windows,
Linux
Analog Digital Interface Mode
Channel 7
Sets the defined Analog/Digital Interface mode for channel
7.
Possible values are:
● 0 — Unused — Channel is unused.
● 1 — ADC Input — Sets the channel mode as Analog-to-
Digital Converter (ADC) input.
● 2 — DAC Output — Sets the channel mode as Digital-
to-Analog Converter (DAC) output.
● 3 — DAC and ADC — Sets the channel mode as DAC
output, but can be monitored through ADC input.
● 8 — GPIO — Sets the channel mode as General
Purpose Input or Output.
Microsoft Windows,
Linux
Analog Digital Interface Mode
Channel 8
Sets the defined Analog/Digital Interface mode for channel
8.
Possible values are:
● 0 — Unused — Channel is unused.
● 1 — ADC Input — Sets the channel mode as Analog-to-
Digital Converter (ADC) input.
● 2 — DAC Output — Sets the channel mode as Digital-
to-Analog Converter (DAC) output.
● 3 — DAC and ADC — Sets the channel mode as DAC
output, but can be monitored through ADC input.
● 8 — GPIO — Sets the channel mode as General
Purpose Input or Output.
Microsoft Windows,
Linux
Attempt Legacy Boot
Determines if BIOS should attempt to boot from the legacy
boot list when the UEFI boot list fails.
Possible values are:
● Enabled — If the UEFI boot list fails, then BIOS
attempts to boot from the Legacy boot list.
Microsoft Windows,
Linux
258 BIOS settings supported in Dell Command | Monitor 10.2.1