Reference Guide

Table Of Contents
BIOS settings supported in Dell Command |
Monitor 10.2.1
Following is the list of BIOS settings supported in Dell Command | Monitor.
Table 149. BIOS settings supported in Dell Command | Monitor 10.2.1
BIOS Settings Name Description Supported
Operating
System(s)
Absolute Sets the value to the Absolute interface and controls the
Absolute service.
Possible values:
Enable - If enabled, then the Absolute service is
activated or deactivated.
Disable - If disabled, then the Absolute service does not
run.
Permanently Disabled - If the Absolute interface is
permanently disabled, then the Absolute feature can be
enabled by using the factory reset feature.
Microsoft Windows,
Linux
Active State Power Management
Set the ASPM (Active State Power Management) level.
Possible values are:
Auto There is handshaking between the device and
PCI Express hub to determine the best ASPM mode
supported by the device.
Disabled ASPM power management is turned off
always.
L1 Only ASPM power management is set to use L1.
Microsoft Windows,
Linux
Activity LED
Sets the Network Activity Light Emitting Diode (LED) to
any of the following:
Possible values are:
1 = EnableACPIOSControl Sets the Activity LED
controlled by an Advanced Configuration and Power
Interface (ACPI) operating system and driver.
2 = WirelessLANIndicator Sets the Activity LED as a
wireless Local Area Network (LAN) radio on/off
indicator.
3 = Off Sets the Activity LED to off.
Microsoft Windows,
Linux
AGP Slot
Enables or disables the on-board AGP slot.
Possible values are:
Disable
Enable
Microsoft Windows
AC Power Recovery Mode
Sets AC Power Recovery Mode.
Possible values are:
Off
Last
Microsoft Windows,
Linux
6
252 BIOS settings supported in Dell Command | Monitor 10.2.1