Reference Guide

DCIM_RoleLimitedToTarget
Table 136. RoleLimitedToTarget
Property Description
DefiningRole
The Role whose target set is explicitly defined.
TargetElement
Reference to the target set that can be accessed from the Role.
DCIM_ElementCapacity
Table 137. ElementCapacity
Property Description
Capacity
PhysicalCapacity describes the minimum and maximum requirements, and ability to
support different types of hardware for a PhysicalElement.
Element
The PhysicalElement being described.
DCIM_ServiceAffectsElement
Table 138. ServiceAffectsElement
Property Description
AffectedElement
The Managed Element that is affected by the Service.
AffectingElement
The Service that is affecting the ManagedElement.
AssignedSequence
AssignedSequence is an unsigned integer 'n' that indicates the relative sequence in
which order the ManagedElement instances are affected by the Service, which is
associated to the ManagedElement instances through this class. The implementation
of the Service uses the relative sequence to order all the managed elements
represented by ManagedElements associated through this class for servicing or
prioritizing. When n is a positive integer, it indicates a place in the sequence of
affected elements, with smaller integers indicating earlier positions in the sequence.
NULL or the special value 0 indicates don't care. If two or more affected elements
have the same non-zero sequence number, then the ordering between those
elements is irrelevant, but they must all be serviced in the appropriate order in the
overall sequence. A series of examples will make order of elements clearer: If all
elements affected have the same sequence number, regardless of whether it is 0 or
non-zero, any order is acceptable. The values, 1:ELEMENT A 2:ELEMENT B
1:ELEMENT C 3:ELEMENT D, indicate two acceptable orders: A,C,B,D or C,A,B,D,
since A and C can be ordered in either sequence, but only at the 1 position.
NOTE: The non-zero sequence numbers need not start with 1, and they need
not be consecutive. All that matters is their relative magnitude.
ElementEffects
An enumeration that describes the effect on the ManagedElement. This array
corresponds to the OtherElementEffectsDescriptions array, where the latter
provides details that are related to the high-level effects enumerated by this
property. Additional detail is required if the ElementEffects array contains the value 1
(Other).
Possible values are:
● 0 = Unknown
● 1 = Other
246 Dell Command | Monitor 10.2.1 classes and properties