Reference Guide

Table 131. ElementSettingData (continued)
Property Description
property indicates that the affected property values specified in the associated
SettingData instance may correspond to minimum desired setting values. When
IsMinimum = Not Applicable, this property indicates that the affected property
values specified in the associated SettingData instance is not interpreted with
respect to whether each defines a desired minimum.
Possible values are:
● 0 = Unknown
● 1 = Not Applicable
● 2 = Is Minimum
● 3 = Is Not Minimum
IsNext
An enumerated integer indicating whether or not the referenced setting is the next
setting to be applied. For example, the application could take place on a re-
initialization, reset, reconfiguration request. This could be a permanent setting, or a
setting used only one time, as indicated by the flag. If it is a permanent setting then
the setting is applied every time the managed element reinitializes, until this flag is
manually reset. However, if it is single use, then the flag is automatically cleared
after the settings are applied. Also note that if this flag is specified (i.e. set to value
other than Unknown), then this takes precedence over any SettingData that may
have been specified as Default. For example: If the managed element is a computer
system, and the value of this flag is Is Next, then the setting will be effective next
time the system resets. And, unless this flag is changed, it will persist for subsequent
system resets. However, if this flag is set to Is Next For Single Use, then this
setting will only be used once and the flag would be reset after that to Is Not Next.
So, in the above example, if the system reboots in a quick succession, the setting will
not be used at the second reboot.
Possible values are:
● 0 = Unknown
● 1 = Is Next
● 2 = Is Not Next
● 3 = Is Next For Single Use
IsPending
An enumerated integer that indicates whether or not the referenced
CIM_SettingData instance represents outstanding changes to the configuration of
the referenced CIM_ManagedElement that are known to be pending and are in the
process of being applied. A value of 0 Unknown indicates that the referenced
instance of CIM_SettingData may represent the last configuration applied to the
referenced CIM_ManagedElement. A value of 2 (Is Pending) indicates that the
referenced instance of CIM_SettingData represents outstanding changes to the
configuration of the referenced CIM_ManagedElement that are known to be
pending. A value of 3 (Is Not Pending) indicates that the referenced instance of
CIM_SettingData does not represent outstanding changes to the configuration of
the referenced CIM_ManagedElement.
Possible values are:
● 0 = Unknown
● 2 = Is Pending
● 3 = Is Not Pending
● .. = DMTF Reserved
● 32768.. = Vendor Reserved
ManagedElement
The managed element.
SettingData
The SettingData object that is associated with the element.
244 Dell Command | Monitor 10.2.1 classes and properties