Release Notes

(http://en.community.dell.com/techcenter/extras/m/mediagallery/20383332.aspx

) to set

Peak Shift Configuration. While viewing Intel RAID alerts using DCIM_LogEntry class,

severity is reported as Unknown instead of a Warning message when virtual disk health

state is changed to Rebuilding.

Issue: If the fan is not working as indicated by Health Status and OperationalStatus

attributes, then the attribute Current Status will be blank.

Issue: Dynamic Detection of Virtual Disk and Power Supply Unit (PSU) state is not

supported.

Issue: No alerts are generated for PSU.

Issue: The NonCritical threshold levels for voltage and current cannot be negative

values.

Issue: Setting the NonCritical threshold levels for fans is not supported. For the

attribute SettableThreshold the NonCritical value can be set to Settable.

Issue: For temperature probe, the Upper Critical Threshold level should be greater than

Issue: For most of the laptop or desktop platforms, where current reading and the

Lower and Upper Critical values are not defined, the fan health status in the

DCIM_NumericSensor class will be displayed as ‘Critical failure’.

Issue: Digital signatures are missing for some third party files.

Issue: Setting Lower NonCritical Threshold attributes may not be supported although

SupportedThreshold attribute shows that it is supported.