Reference Guide

Attribute Name Description
After the end time specified the system will run from AC if attached
but will not charge the battery. The system will again function
normally using AC and recharging the battery after the Charge Start
time is specified.
Possible values are:
• 1 — Disable
• 2 — Enable
Peak Shift Sun
This attribute configures the power usage configuration for Sunday.
Possible values are:
• 0 — 23 — Start Hour
• 0 — 59 — Start Minute
• 0 — 23 — End Hour
• 0 — 59 — End Minute
• 0 — 23 — Charge Start Hour
• 0 — 59 — Charge Start Min
Attribute names for Set operation:
• Peak Shift Sun StartHour
• Peak Shift Sun StartMin
• Peak Shift Sun EndHour
• Peak Shift Sun EndMin
• Peak Shift Sun ChargeStartHour
• Peak Shift Sun ChargeStartMin
NOTE: To use Peak Shift mode, the values of Peak Shift Start
Time, Peak Shift End Time, Peak Shift Charge Start Time, and
Peak Shift battery threshold are necessary.
NOTE: It is recommended to input values as per the following:
Start Time <= End Time <= Charge Start Time. Dell Command |
Monitor can set the out-of-range values. BIOS behavior is
unknown at this point of time for such values.
NOTE: The values defined for Minute field are 0,15,30 and 45. In
case you set any other value, the value is round to the lower
defined value.
Peak Shift Mon
This attribute configures the power usage configuration for Monday.
Possible values are:
• 0 — 23 — Start Hour
• 0 — 59 — Start Minute
• 0 — 23 — End Hour
• 0 — 59 — End Minute
• 0 — 23 — Charge Start Hour
• 0 — 59 — Charge Start Min
323