Reference Guide

Property Description
A return code of 0 shall indicate the state change was successfully
initiated.
A return code of 3 shall indicate that the state transition cannot
complete within the interval specified by the TimeoutPeriod
parameter.
A return code of 4096 (0x1000) shall indicate the state change was
successfully initiated, a ConcreteJob has been created, and its
reference returned in the output parameter Job. Any other return
code indicates an error condition.
DCIM_RecordLog
Property Description
ElementName
ElementName A user-friendly name for the object. This property
allows each instance to define a user-friendly name in addition to its
key properties, identity data, and description information.
NOTE: The Name property of ManagedSystemElement is also
defined as a user-friendly name. But, it is often subclassed to be a
Key. It is not reasonable that the same property can convey both
identity and a user-friendly name, without inconsistencies. Where
Name exists and is not a Key (such as for instances of
LogicalDevice), the same information can be present in both the
Name and ElementName properties.
EnabledDefault
An enumerated value indicating an administrator's default or startup
configuration for the Enabled State of an element.
Possible values are:
• 2 = Enabled
• 3 = Disabled
• 5 = Not Applicable
• 6 = Enabled but Offline
• 7 = No Default
• 9 = Quiesce
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState
An integer enumeration that indicates the enabled and disabled states
of an element. It can also indicate the transitions between these
requested states. For example, shutting down (value = 4) and starting
(value = 10) are transient states between enabled and disabled.
Possible values are:
• 0 = Unknown
• 1 = Other
209