Reference Guide

Property Description
When instrumented, Status (because it is single-valued) should also
provide the primary status of the element.
PrimaryStatus
Provides a high level status value, intended to align with Red-Yellow-
Green type representation of status. It should be used in conjunction
with DetailedStatus to provide high level and detailed health status of
the ManagedElement and its subcomponents.
Possible values are:
• 0 = Unknown — Indicates the implementation is in general
capable of returning this property, but is unable to do so at this
time.
• 1 = OK — Indicates the ManagedElement is functioning normally.
• 2 = Degraded — Indicates the ManagedElement is functioning
below normal.
• 3 = Error - Indicates the ManagedElement is in an Error condition.
• .. = DMTF Reserved
• 0x8000.. = Vendor Reserved
RequestedState
An integer enumeration that indicates the last requested or desired
state for the element, irrespective of the mechanism through which it
was requested. The actual state of the element is represented by
EnabledState. This property is provided to compare the last requested
and current enabled or disabled states.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change
• 6 = Offline
• 7 = Test
• 8 = Deferred
• 9 = Quiesce
• 10 = Reboot
• 11 = Reset
• 12 = Not Applicable
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
NOTE: When EnabledState is set to 5 (Not Applicable), then this
property has no meaning. Refer to the EnabledState property
description for explanations of the values in the RequestedState
enumeration. Unknown (0) indicates the last requested state for
the element is unknown.
141