Reference Guide

Property Description
NOTE: The Name property of ManagedSystemElement is also defined as a
user-friendly name. But, it is often subclassed to be a Key. It is not reasonable
that the same property can convey both identity and a user-friendly name,
without inconsistencies. Where Name exists and is not a Key (such as for
instances of LogicalDevice), the same information can be present in both the
Name and ElementName properties.
HorizontalResolution
The horizontal resolution in Pixels of the flat panel.
MaxQuiesceTime
The use of this property has been deprecated. When evaluating the use of Quiesce, it was
determined that this single property is not adequate for describing when a device will
automatically exit a quiescent state. In fact, the most likely scenario for a device to exit a
quiescent state was determined to be based on the number of outstanding requests
queued rather than on a maximum time. This decision will be re-evaluated and repositioned
later. Deprecated description: Maximum time, in milliseconds, that a Device can run in a
Quiesced state. The state is defined in its Availability and Additional Availability properties,
where Quiesced is conveyed by the value 21. What occurs at the end of the time limit is
device-specific. The Device can unquiesce, can be offline, or can take other actions. A value
of 0 indicates that a Device can remain quiesced indefinitely.
ScanMode
The scan mode of a flat panel indicating either single (value = 2) or dual scan 3.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Single Scan
• 3 = Dual Scan
SystemCreationClassName
The creation class name of the scoping system.
SystemName
The system name of the scoping system.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change — Indicates that no transition is in progress.
• 6 = Offline
• 7 = Test
• 8 = Defer
• 9 = Quiesce
• 10 = Reboot
• 11 = Reset
• 12 = Not Applicable — Indicates that the implementation does not support representing
ongoing transitions.
A value other than 5 or 12 identifies the state to which the element is in the process of
transitioning.
VerticalResolution
Vertical resolution in Pixels of a flat panel.
48 Dell Command | Monitor 10.3 classes and properties