Reference Guide

Property Description
property indicates that the affected property values specified in the
associated SettingData instance does not define desired minimum setting
values. When IsMinimum = Unknown, this property indicates that the affected
property values specified in the associated SettingData instance may
correspond to minimum desired setting values. When IsMinimum = Not
Applicable, this property indicates that the affected property values specified
in the associated SettingData instance is not interpreted with respect to
whether each defines a desired minimum.
Possible values are:
• 0 = Unknown
• 1 = Not Applicable
• 2 = Is Minimum
• 3 = Is Not Minimum
IsNext
An enumerated integer indicating whether or not the referenced setting is the next setting
to be applied. For example, the application could take place on a re-initialization, reset,
reconfiguration request. This could be a permanent setting, or a setting used only one time,
as indicated by the flag. If it is a permanent setting then the setting is applied every time
the managed element reinitializes, until this flag is manually reset. However, if it is single use,
then the flag is automatically cleared after the settings are applied. Also note that if this flag
is specified (i.e. set to value other than Unknown), then this takes precedence over any
SettingData that may have been specified as Default. For example: If the managed element
is a computer system, and the value of this flag is Is Next, then the setting will be effective
next time the system resets. And, unless this flag is changed, it will persist for subsequent
system resets. However, if this flag is set to Is Next For Single Use, then this setting will
only be used once and the flag would be reset after that to Is Not Next. So, in the above
example, if the system reboots in a quick succession, the setting will not be used at the
second reboot.
Possible values are:
• 0 = Unknown
• 1 = Is Next
• 2 = Is Not Next
• 3 = Is Next For Single Use
IsPending
An enumerated integer that indicates whether or not the referenced CIM_SettingData
instance represents outstanding changes to the configuration of the referenced
CIM_ManagedElement that are known to be pending and are in the process of being
applied. A value of 0 Unknown indicates that the referenced instance of CIM_SettingData
may represent the last configuration applied to the referenced CIM_ManagedElement. A
value of 2 (Is Pending) indicates that the referenced instance of CIM_SettingData
represents outstanding changes to the configuration of the referenced
CIM_ManagedElement that are known to be pending. A value of 3 (Is Not Pending)
indicates that the referenced instance of CIM_SettingData does not represent outstanding
changes to the configuration of the referenced CIM_ManagedElement.
Possible values are:
• 0 = Unknown
• 2 = Is Pending
• 3 = Is Not Pending
• .. = DMTF Reserved
• 32768.. = Vendor Reserved
ManagedElement
The managed element.
SettingData
The SettingData object that is associated with the element.
Dell Command | Monitor 10.3 classes and properties 233