Reference Guide

Property Description
Possible values are:
• 0 = Unknown — Indicates the log's overwrite policy is unknown.
• 2 = Wraps When Full — Indicates that the log overwrites its entries with new entries
when the log has reached its maximum capacity.
• 7 = Never Overwrites — Indicates that the log never overwrites its entries by the new
entries
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
PrimaryStatus
Provides a high level status value, intended to align with Red-Yellow-Green type
representation of status. It should be used in conjunction with DetailedStatus to provide high
level and detailed health status of the ManagedElement and its subcomponents.
Possible values are:
• 0 = Unknown — Indicates the implementation is in general capable of returning this
property, but is unable to do so at this time.
• 1 = OK — Indicates the ManagedElement is functioning normally.
• 2 = Degraded — Indicates the ManagedElement is functioning below normal.
• 3 = Error — Indicates the ManagedElement is in an Error condition.
• .. = DMTF Reserved
• 0x8000.. = Vendor Reserved
RequestedState
An integer enumeration that indicates the last requested or desired state for the element,
irrespective of the mechanism through which it was requested.
Possible values are:
• 0 = Unknown — Indicates the last requested state for the element is unknown.
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change
• 6 = Offline — Indicates that the element has been requested to transition to the
Enabled but Offline EnabledState.
• 7 = Test
• 8 = Deferred
• 9 = Quiesce
• 10 = Reboot — Refers to doing a Shut Down and then moving to an Enabled state.
• 11 = Reset — Indicates that the element is first Disabled and then Enabled.
• 12 = Not Applicable
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
The actual state of the element is represented by EnabledState. This property is provided to
compare the last requested and current enabled or disabled states. Note that when
EnabledState is set to 5 (Not Applicable), then this property has no meaning. Refer to the
EnabledState property description for explanations of the values in the RequestedState
enumeration.
NOTE:
The value No Change (5) has been deprecated instead of indicating the
last requested state is Unknown (0). If the last requested or desired state is
unknown, RequestedState should have the value Unknown (0), but may have
the value No Change (5).
There are two new values in RequestedState that build on the statuses of EnabledState.
These are Reboot (10) and Reset (11). Shut Down requests an orderly transition to the
Disabled state, and may involve removing power, to completely erase any existing state. The
Disabled state requests an immediate disabling of the element, such that it will not execute
or accept any commands or processing requests.
170
Dell Command | Monitor 10.3 classes and properties