Reference Guide

Property Description
• 10 = Reboot
• 11 = Reset
• 12 = Not Applicable
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
SensorType
The Type of the Sensor, e.g. Voltage or Temperature Sensor. If the type is set to Other,
then the OtherSensorType Description can be used to further identify the type, or if the
Sensor has numeric readings, then the type of the Sensor can be implicitly determined by
the Units. A description of the different Sensor types is as follows: A Temperature Sensor
measures the environmental temperature. Voltage and Current Sensors measure electrical
voltage and current readings. A Tachometer measures speed/revolutions of a Device. For
example, a Fan Device can have an associated Tachometer which measures its speed. A
Counter is a general purpose Sensor that measures some numerical property of a Device. A
Counter value can be cleared, but it never decreases. A Switch Sensor has states like
Open/Close, On/Off, or Up/Down. A Lock has states of Locked/Unlocked. Humidity,
Smoke Detection and Air Flow Sensors measure the equivalent environmental
characteristics. A Presence Sensor detects the presence of a PhysicalElement. A Power
Consumption Sensor measures the instantaneous power consumed by a managed element.
A Power Production Sensor measures the instantaneous power produced by a managed
element such as a power supply or a voltage regulator. A pressure sensor is used to report
pressure. Intrusion sensor reports an intrusion of an enclosure regardless whether it was
authorized or not.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Temperature
• 3 = Voltage
• 4 = Current
• 5 = Tachometer
• 6 = Counter
• 7 = Switch
• 8 = Lock
• 9 = Humidity
• 10 = Smoke Detection
• 11 = Presence
• 12 = Air Flow
• 13 = Power Consumption
• 14 = Power Production
• 15 = Pressure
• 16 = Intrusion
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
SystemCreationClassName
The CreationClassName of the scoping system.
SystemName
The System Name of the scoping system.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change — Indicates that no transition is in progress.
• 6 = Offline
128 Dell Command | Monitor 10.2.1 classes and properties