Reference Guide

DCIM_Button
Table 35. Button
Property Description
ButtonPurpose
The ButtonPurpose property identifies or defines the use of the button represented by the
instance. If the type is set to Other, then the OtherButtonPurpose property can be used to
further identify the purpose. Descriptions of the different Button purposes are as follows: A
Power Button changes the power state of a device. A reset button is used to reset the
state of a device. Undock is used to undock or disconnect a device or entire system from a
separate device or system. An Open or Close button is used on a device that has an object
that usually moves such as a drawer, door, or tray.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Power
• 3 = Reset
• 4 = Undock
• 5 = Open/Close
• 6..32767 = DMTF Reserved
• 32768..65535 = Vendor Reserved
ButtonType
The ButtonType property identifies or defines the type the button represented by the
instance.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Momentary
• 3 = Toggle
• 4..32767 = DMTF Reserved
• 32768..65535 = Vendor Reserved
If the type is set to Other, then the OtherButtonType property can be used to further
identify the type. A momentary button is one that depressed for a moment to cause the
desired affect the target device or circuit A toggle type button is one that will remain in a
switched or depressed position until it is depressed or switched again.
CreationClassName
Indicates the name of the class or the subclass used in the creation of an instance. When
used with the other key properties of this class, this property allows all instances of this
class and its subclasses to be uniquely identified.
DeviceID
An address or other identifying information used to uniquely name the LogicalDevice.
EnabledDefault
An enumerated value indicating an administrator's default or startup configuration for the
Enabled State of an element.
Possible values are:
• 2 = Enabled
• 3 = Disabled
• 5 = Not Applicable
• 6 = Enabled but Offline
• 7 = No Default
• 9 = Quiesce
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
Dell Command | Monitor 10.2.1 classes and properties 135