Reference Guide

Property Description
OperationalStatus properties. Further, the first value of OperationalStatus should contain
the primary status for the element. When instrumented, Status (because it is single-valued)
should also provide the primary status of the element.
OtherIdentifyingInfo
OtherIdentifyingInfo captures data, in addition to DeviceID information, that could be used
to identify a LogicalDevice. For example, you could use this property to hold the operating
system's user-friendly name for the Device.
PrimaryStatus
Provides a high level status value, intended to align with Red-Yellow-Green type
representation of status. It should be used in conjunction with DetailedStatus to provide
high level and detailed health status of the ManagedElement and its subcomponents.
Possible values are:
• 0 = Unknown — Indicates the implementation is in general capable of returning this
property, but is unable to do so at this time.
• 1 = OK — Indicates the ManagedElement is functioning normally.
• 2 = Degraded — Indicates the ManagedElement is functioning below normal.
• 3 = Error — Indicates the ManagedElement is in an Error condition.
• .. = DMTF Reserved
• 0x8000.. = Vendor Reserved
RemainingCapacityMaxError
The maximum error (as a percentage) in the mWatt-hour data reported by
RemainingCapacity property.
RequestedState
An integer enumeration that indicates the last requested or desired state for the element,
irrespective of the mechanism through which it was requested. The actual state of the
element is represented by EnabledState. This property is provided to compare the last
requested and current enabled or disabled states.
Possible values are:
• 0 = Unknown — Indicates the last requested state for the element is unknown.
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change
• 6 = Offline — Indicates that the element has been requested to transition to the
Enabled but Offline EnabledState.
• 7 = Test
• 8 = Deferred
• 9 = Quiesce
• 10 = Reboot — Refers to doing a Shut Down and then moving to an Enabled state.
• 11 = Reset — Indicates that the element is first Disabled and then Enabled.
• 12 = Not Applicable
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
NOTE: When EnabledState is set to 5 (Not Applicable), then this property has
no meaning. Refer to the EnabledState property description for explanations
of the values in the RequestedState enumeration.
NOTE: The value No Change (5) has been deprecated instead of indicating the
last requested state is Unknown (0). If the last requested or desired state is
unknown, RequestedState should have the value Unknown (0), but may have
the value No Change (5).
There are two new values in RequestedState that build on the statuses of EnabledState.
These are Reboot (10) and Reset (11).
Shut Down requests an orderly transition to the Disabled state, and may involve removing
power, to completely erase any existing state. The Disabled state requests an immediate
106
Dell Command | Monitor 10.2.1 classes and properties