Reference Guide

Property Description
can also be specified to indicate that the current speed is
unknown or 1 to indicate that the speed is other than 1.5 or
12Mbps. Possible values are: 0, 1, 1500000, 12000000
SystemCreationClassName
The CreationClassName of the scoping system.
SystemName
The System Name of the scoping system.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change — Indicates that no transition is in progress.
• 6 = Offline
• 7 = Test
• 8 = Defer
• 9 = Quiesce
• 10 = Reboot
• 11 = Reset
• 12 = Not Applicable — Indicates the implementation does not
support representing ongoing transitions.
A value other than 5 or 12 identifies the state to which the element
is in the process of transitioning.
DCIM_Memory
Table 23. Memory
Property Description
Access
Access describes whether the media is readable (value = 1),
writeable (value = 2), or both (value = 3). Unknown (0) and
Write Once (4) can also be defined.
Possible values are:
• 0 = Unknown
• 1 = Readable
• 2 = Writeable
• 3 = Read/Write Supported
• 4 = Write Once
BlockSize
Size in bytes of the blocks which form this StorageExtent. If
variable block size, then the maximum block size in bytes should be
specified. If the block size is unknown or if a block concept is not
valid (for example, for AggregateExtents, Memory or LogicalDisks),
enter a 1.
ConsumableBlocks
The maximum number of blocks, of size BlockSize, which are
available for consumption when layering StorageExtents using the
BasedOn association. This property only has meaning when this
StorageExtent is an Antecedent reference in a BasedOn
relationship. For example, a StorageExtent could be composed of
120 blocks. However, the Extent itself may use 20 blocks for
redundancy data. If another StorageExtent is BasedOn this Extent,
only 100 blocks would be available to it. This information (100
82 Dell Command | Monitor 10.2.1 classes and properties