Reference Guide

DCIM_Slot
Table 20. Slot
Property Description
ConnectorLayout
Describes the type of packaging normally associated with this type
of connector.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = RS232
• 3 = BNC
• 4 = RJ11
• 5 = RJ45
• 6 = DB9
• 7 = Slot
• 8 = SCSI High Density
• 9 = SCSI Low Density
• 10 = Ribbon
• 11 = AUI
• 12 = Fiber SC
• 13 = Fiber ST
• 14 = FDDI-MIC
• 15 = Fiber-RTMJ
• 16 = PCI — Describes the generic PCI connector layout.
• 17 = PCI-X — Describes the PCI Extended connector layout.
• 18 = PCI-E — Describes the PCI Express connector layout,
where the actual layout with respect to the length is unknown.
• 19 = PCI-E x1
• 20 = PCI-E x2
• 21 = PCI-E x4
• 22 = PCI-E x8
• 23 = PCI-E x16
• 24 = PCI-E x32
• 25 = PCI-E x64
• 26..32567 = DMTF Reserved
• 32568..65535 = Vendor Reserved
19 — 25 (PCI-E xN) — Describes the PCI Express connector
layout, where N is the lane count that appropriately describes the
length of the PCI-E connector.
ConnectorType
An array of integers defining the type of PhysicalConnector. An
array is specified to allow the description of combinations of
Connector information.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Male
• 3 = Female
• 4 = Shielded
• 5 = Unshielded
• 6 = SCSI (A) High-Density (50 pins)
• 7 = SCSI (A) Low-Density (50 pins)
• 8 = SCSI (P) High-Density (68 pins)
• 9 = SCSI SCA-I (80 pins)
Dell Command | Monitor 10.2.1 classes and properties 69