Reference Guide

DCIM_SMARTAttributeInfo
Table 144. SMARTAttributeInfo
Property Description
AttributeID AttributeID represents the relative reliability of individual performance or
calibration attributes. The valid range of attribute values begins from 1–253
decimal.
AttributeName Name defined for the corresponding AttributeID.
CurrentValue
Current value of an attribute which represents the relative reliability of
individual performance or calibration attributes.
CustomThresholdValue
Each attribute has a corresponding Custom Threshold Value which is
used for direct comparison to the Current Value to indicate the existence
of a degrading or faulty condition. The numerical value of the
Custom
Threshold Value is determined by the IT administrator and set the value
lesser than the Threshold Value set by the Manufacturer. The valid range
for Attribute Thresholds is from 1–253 decimal.
DiskID Disk ID of the HDD/SSD.
FirmwareVersion Firmware Version of the HDD/SSD.
Manufacturer HDD/SSD Manufacturer.
ModelNumber HDD/SSD Model Number.
RawDataContent Raw data content in hexadecimal for the corresponding AttributeID (6
bytes).
SerialNumber HDD/SSD Serial Number.
StatusFlag A 2-byte number which represents the status of the corresponding
AttributeID:
• Bit 0: Prefail/Advisory bit
• Bit 1: Online data collection bit
• Bit 2–5: Vendor-specific
• Bit 6–15: Reserved
ThresholdValue The (failure) limit of the attribute.
WorstValue The worst (smallest) value ever found in the previous lifetime of the storage
device.
SetCustomThreshold (Method)
This property represents the success or failure of the SMART operation.
The method may return the following errors:
• 0 (Success) - If the method is completed successfully.
• 1 (Failure) - If the Input parameter is out of range or IO operation fails.
DCIM_SettingsDefineState
Table 145. SettingsDefineState
Property Description
ManagedElement
The managed element.
SettingData
The SettingData object that provides additional information about the current state and
configuration of the ManagedElement.
238 Dell Command | Monitor 10.2.1 classes and properties