Reference Guide

DCIM_IPProtocolEndpoint
Table 11. IPProtocolEndpoint
Property Description
AddressOrigin
Identifies the method by which the IP Address, Subnet Mask, and
Gateway were assigned to the IPProtocolEndpoint.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Not Applicable
• 3 = Static — Indicates the values were assigned manually.
• 4 = DHCP — Indicates the values were assigned utilizing the
Dynamic Host Configuration Protocol. See RFC 2131 and
related.
• 5 = BOOTP — Indicates the values were assigned utilizing
BOOTP. See RFC 951 and related.
• 6 = IPv4 Link Local — Indicates the values were assigned using
the IPv4 Link Local protocol. See RFC 3927.
• 7 = DHCPv6 — Indicates the values were assigned using
DHCPv6. See RFC 3315.
• 8 = IPv6AutoConfig — Indicates the values were assigned
using the IPv6 AutoConfig Protocol. See RFC 4862.
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
CreationClassName
Indicates the name of the class or the subclass used in the creation
of an instance. When used with the other key properties of this
class, this property allows all instances of this class and its
subclasses to be uniquely identified.
ElementName
A user-friendly name for the object. This property allows each
instance to define a user-friendly name in addition to its key
properties, identity data, and description information.
NOTE: The Name property of ManagedSystemElement is
also defined as a user-friendly name. But, it is often sub-
classed to be a Key. It is not reasonable that the same
property can convey both identity and a user-friendly
name, without inconsistencies. Where Name exists and
is not a Key (such as for instances of LogicalDevice), the
same information can be present in both the Name and
ElementName properties.
EnabledDefault
An enumerated value indicating an administrator's default or
startup configuration for the Enabled State of an element.
Possible values are:
• 2 = Enabled
• 3 = Disabled
• 5 = Not Applicable
• 6 = Enabled but Offline
• 7 = No Default
• 9 = Quiesce
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2) .
Dell Command | Monitor 10.2.1 classes and properties 49