Reference Guide

Property Description
OtherAlertType
A string describing the Alert type - used when the Alert type property is set to 1, Other
State Change.
PollEnabled
This property shows if status-polling of the event source is enabled or not. TRUE for
enable, and FALSE for disabled.
PollingInterval
The polling interval for event source, in seconds.
ProbableCause
An enumerated value that describes the probable cause of the situation which resulted in
the AlertIndication.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Adapter/Card Error
• 3 = Application Subsystem Failure
• 4 = Bandwidth Reduced
• 5 = Connection Establishment Error
• 6 = Communications Protocol Error
• 7 = Communications Subsystem Failure
• 8 = Configuration/Customization Error
• 9 = Congestion
• 10 = Corrupt Data
• 11 = CPU Cycles Limit Exceeded
• 12 = Dataset/Modem Error
• 13 = Degraded Signal
• 14 = DTE-DCE Interface Error
• 15 = Enclosure Door Open
• 16 = Equipment Malfunction
• 17 = Excessive Vibration
• 18 = File Format Error
• 19 = Fire Detected
• 20 = Flood Detected
• 21 = Framing Error
• 22 = HVAC Problem
• 23 = Humidity Unacceptable
• 24 = I/O Device Error
• 25 = Input Device Error
• 26 = LAN Error
• 27 = Non-Toxic Leak Detected
• 28 = Local Node Transmission Error
• 29 = Loss of Frame
• 30 = Loss of Signal
• 31 = Material Supply Exhausted
• 32 = Multiplexer Problem
• 33 = Out of Memory
• 34 = Output Device Error
• 35 = Performance Degraded
• 36 = Power Problem
• 37 = Pressure Unacceptable
• 38 = Processor Problem (Internal Machine Error)
• 39 = Pump Failure
• 40 = Queue Size Exceeded
• 41 = Receive Failure
• 42 = Receiver Failure
• 43 = Remote Node Transmission Error
194
Dell Command | Monitor 10.2.1 classes and properties