Release Notes

Issue: Class DCIM_PhysicalDiskView enumerates only IDE disk drives for Intel controller.

Issue: The value of Link technology property in DCIM_EthernetPort class appears empty.

Description: If the value of any attributes is not in English, then that attributes eld may appear blank. For example,

DCIM_EthernetPort_LinkTechnology. Dell Command | Monitor is not localized and is an English language application; however, Dell

Command | Monitor can be installed on other OS language versions such as French, German, Spanish, Japanese, Korean, Simplied

Chinese, and Traditional Chinese of supported Windows operating systems.

Issue: Dell Command | Monitor allows enabling Secure Boot when Legacy Option ROM is enabled and boot mode is UEFI; however, there is

no negative impact due to this on the BIOS. This issue will be addressed in the upcoming BIOS versions.

Issue: If the fan is not working as indicated by Health Status and OperationalStatus attributes, then the attributes Current Status will be

blank.

Issue: The NonCritical threshold levels for voltage and current cannot be negative values.

Issue: Setting the NonCritical threshold levels for fans is not supported. For the attributes SettableThreshold the NonCritical value can be

set to Settable.

Issue: For temperature probe, the Upper Critical Threshold level should be greater than 0.

Issue: Digital signatures are missing for some third party les.

Issue: Setting Lower NonCritical Threshold attributes may not be supported although SupportedThreshold attributes shows that it is

supported.

Issue: If the values of Upper NonCritical Threshold for NumericSensor class are close to reading or status values, then an event might be

generated although the same might not be shown in the class attributes.

Issue: Lower Threshold alerts are not generated; however, they can be monitored using the Current State attributes in NumericSensor

class.

Issue: Degraded status and alert for physical disk is not supported with LSI controllers.

Issue: In LogEntry the element name for alerts is displayed as Alert Log Entry <Alert ID>.

Issue: While stopping the data manager service, an error message might be displayed saying the process cannot be stopped. But the

service will be stopped.

Issue: For LSI controllers, status or event may not be generated when the Battery Backup Unit (BBU) is degraded.

Resolution: The BBU degraded status can be viewed in the application log for event (Id #161 of category type: Warning) generated by

source MR_MONITOR.

Issue: After upgrading from Windows OS, enumerating WMI classes may not display appropriate results.

Resolution: Reinstall Dell Command | Monitor to the newer build or repair the build from control panel.

Issue: Error message might be displayed in Application Log of event viewer while restarting the system or service.

Issue: Hyper-v does not work

Description: Hyper-v doesn’t work if Dell Command | Monitor is installed for the rst time on clean installation of Windows 10.

Resoultion: Rebuild Hyper V WMI repository by executing the command:

MOFCOMP <SYSTEMROOT>\System32\WindowsVirtualization.V2.mof

Issue: DCIM_Docked class displays value Unknown for ElementName property.

Known Issues