Reference Guide

Property Description
NOTE: When EnabledState is set to 5 (Not Applicable),
then this property has no meaning. Refer to the
EnabledState property description for explanations of the
values in the RequestedState enumeration.
NOTE: The value No Change (5) has been deprecated
instead of indicating the last requested state is Unknown
(0). If the last requested or desired state is unknown,
RequestedState should have the value Unknown (0), but
may have the value
No Change (5).
There are two new values in RequestedState that build on the
statuses of EnabledState. These are Reboot (10) and Reset (11).
Shut Down requests an orderly transition to the Disabled state, and
may involve removing power, to completely erase any existing state.
The Disabled state requests an immediate disabling of the element,
such that it will not execute or accept any commands or processing
requests. This property is set as the result of a method invocation
(such as Start or StopService on CIM_Service), or can be
overridden and dened as WRITEable in a subclass. The method
approach is considered superior to a WRITEable property, because
it allows an explicit invocation of the operation and the return of a
result code. If knowledge of the last RequestedState is not
supported for the EnabledLogicalElement, the property is NULL or
has the value 12 (Not Applicable).
Possible values are:
• 0 = Unknown — Indicates the last requested state for the
element is unknown.
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change
• 6 = Oine — Indicates that the element has been requested to
transition to the Enabled but Oine EnabledState.
• 7 = Test
• 8 = Deferred
• 9 = Quiesce
• 10 = Reboot — Refers to doing a Shut Down and then moving
to an Enabled state.
• 11 = Reset - Indicates that the element is rst Disabled and then
Enabled.
• 12 = Not Applicable
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
SystemCreationClassName
The CreationClassName of the scoping system.
SystemName
The System Name of the scoping system.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change — Indicates that no transition is in progress.
90 Dell Command | Monitor10.1.0 classes and properties