Reference Guide
Property Description
• 16193 = Serial Port
• 16194 = Pointing Device
• 16195 = Keyboard
• 16196 = Processor
• 16197 = Memory Device
• 16198 = USB
• 16199 = Monitor
• 16200 = SCSI
• 16201..65535 = Vendor Reserved
PrimaryStatus
Provides a high-level status value, intended to align with Red-
Yellow-Green type representation of status. It should be used with
DetailedStatus to provide high level and detailed health status of
the ManagedElement and its subcomponents.
Possible values are:
• 0 = Unknown — Indicates that the implementation is in general
capable of returning this property, but is unable to do so now.
• 1 = OK — Indicates the ManagedElement is functioning
normally.
• 2 = Degraded — Indicates the ManagedElement is functioning
below normal.
• 3 = Error — Indicates the ManagedElement is in an Error
condition.
• .. = DMTF Reserved
• 0x8000.. = Vendor Reserved
RequestedSpeed
The requested bandwidth of the Port in Bits per Second. The actual
bandwidth is reported in LogicalPort.Speed.
RequestedState
An integer enumeration that indicates the last requested or desired
state for the element, irrespective of the mechanism through which
it was requested. The actual state of the element is represented by
EnabledState. This property is provided to compare the last
requested and current enabled or disabled states. When
EnabledState is set to 5 (Not Applicable), then this property has no
meaning. Refer to the EnabledState property description for
explanations of the values in the RequestedState enumeration.
NOTE: The value No Change (5)has been deprecated
instead of indicating the last requested state is Unknown
(0). If the last requested or desired state is unknown,
RequestedState should have the value Unknown (0), but
may have the value
No Change (5). There are two new
values in RequestedState that build on the statuses of
EnabledState. These are Reboot (10) and Reset (11).
Shut Down requests an orderly transition to the Disabled state, and
may involve removing power, to completely erase any existing state.
The Disabled state requests an immediate disabling of the element,
such that it will not execute or accept any commands or processing
requests. This property is set as the result of a method invocation
(such as Start or StopService on CIM_Service), or can be
overridden and dened as WRITEable in a subclass. The method
approach is considered superior to a WRITEable property, because
it allows an explicit invocation of the operation and the return of a
result code. If knowledge of the last RequestedState is not
supported for the EnabledLogicalElement, the property is NULL or
has the value 12
Not Applicable.
80
Dell Command | Monitor10.1.0 classes and properties