Reference Guide

Property Description
Pinout
The pinout used by the I/O device on this parallel port.
Possible values are:
• 0 = Unknown
• 1 = XT/AT
• 2 = PS/2
• 3 = ECP
• 4 = EPP
• 5 = IEEE 1284
• 25 = PC-98
• 26 = PC-98-Hireso
• .. = DMTF Reserved
RequestedState
An integer enumeration that indicates the last requested or desired
state for the element, irrespective of the mechanism through which
it was requested. The actual state of the element is represented by
EnabledState. This property is provided to compare the last
requested and current enabled or disabled states. Note that when
EnabledState is set to 5 (Not Applicable), then this property has
no meaning. Refer to the EnabledState property description for
explanations of the values in the RequestedState enumeration.
Unknown (0) indicates the last requested state for the element is
unknown.
NOTE: The value No Change (5) has been deprecated
instead of indicating the last requested state is Unknown
(0). If the last requested or desired state is unknown,
RequestedState should have the value Unknown (0), but
may have the value
No Change (5).Oine (6) indicates
that the element has been requested to transition to the
Enabled but Oine EnabledState. There are two new
values in RequestedState that build on the statuses of
EnabledState. These are Reboot (10) and Reset (11). Shut
Down requests an orderly transition to the Disabled state,
and may involve removing power, to completely erase any
existing state. The Disabled state requests an immediate
disabling of the element, such that it will not execute or
accept any commands or processing requests. This
property is set as the result of a method invocation (such
as Start or StopService on CIM_Service), or can be
overridden and dened as WRITEable in a subclass. The
method approach is considered superior to a WRITEable
property, because it allows an explicit invocation of the
operation and the return of a result code. If knowledge of
the last RequestedState is not supported for the
EnabledLogicalElement, the pro
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change
• 6 = Oine
• 7 = Test
• 8 = Deferred
• 9 = Quiesce
66
Dell Command | Monitor10.1.0 classes and properties