Reference Guide
Property Description
Tag
Species the Service Tag.
Value
Pin Value can be either 0 or 1, where 0 indicates low and 1 indicates high.
NOTE: Based on the requirement, the mode value for all pins can be
from 0–63 for Embedded Box PC 3000 and 0–255 for Embedded Box
PC 5000.
SetResult
This property represents the success or failure of the GPIO operation.
The method may return the following errors:
• 0 (Success) - If the method is completed successfully.
• 1 (Failure) - If the Input parameter is out of range or IO operation fails.
NOTE: Based on the requirement, the mode value for all pins can be
from 0–63 for Embedded Box PC 3000 and 0–255 for Embedded Box
PC 5000.
ReadPin (Method)
This method is used for reading the Pin Value.
The input parameters are Port and PinIndex.
WritePin (Method)
This method is used for writing the Pin Value.
The input parameters are Port, PinIndex, and Value.
ReadAllPins (Method)
This method is used for reading the value of all pins.
The input parameter is Port.
WriteAllPins (Method)
This method is used for writing the value of all pins.
The input parameters are Port and Value.
GetPinMode (Method)
This method is used to get the Pin Mode value.
The input parameters are Port and PinIndex.
SetPinMode (Method)
This method is used to set the Pin Mode value.
The input parameters are Port, PinIndex, and Mode.
GetAllPinModes (Method)
This method is used to get all the Pin Mode values.
The input parameter is Port.
SetAllPinModes (Method)
This method is used to set all the Pin Mode values.
The input parameters are Port and Mode.
GetPinCount (Method)
This method returns the total number of input and output pins.
Total number of input and output pins are parameters for GetPinCount
method.
50 Dell Command | Monitor10.1.0 classes and properties