Reference Guide

Property Description
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change — Indicates that no transition is in progress.
• 6 = Oine
• 7 = Test
• 8 = Defer
• 9 = Quiesce
• 10 = Reboot
• 11 = Reset
• 12 = Not Applicable — Indicates that the implementation does not support representing
ongoing transitions.
A value other than 5 or 12 identies the state to which the element is in the process of
transitioning.
VerticalResolution
Vertical resolution in Pixels of a at panel.
DCIM_GPIOService
This class is applicable only for Embedded Box PC 3000/5000.
Property
Description
ComputerName
Provides the congured computer name.
Mode
Mode value for a pin can be either 0 or 1, where 0 indicates output and 1
indicates input.
NOTE: Based on the requirement, the mode value for all pins can be
from 0–63 for Embedded Box PC 3000.
Model
Model name of the system.
Port
Species the Port number of the device based on which the IO operation is
intended.
For Embedded Box PC 3000, the port Numbers are 0 and 1. Each port
comprises of 6 pins each. User is required to pass the appropriate port to be
able to congure the set of 6 pins on the respective port.
NOTE: Conguring all pins at a time is limited by the port, for
conguring All Pins Mode on Embedded Box PC 3000 Platform,
two calls are required to be issued for Port 0 and Port 1.
NOTE: Port is applicable for Embedded Box PC 3000.
PinIndex
• Species the PinIndex number in the corresponding port. The index is
calculated as 0 from right to left in each Port.
• For Embedded Box PC 3000, the index range is from 0–5.
• For Embedded Box PC 5000, the index range is from 0–7.
Dell Command | Monitor10.1.0 classes and properties 49