Reference Guide

Property Description
• 3 = False
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
CreationClassName
Indicates the name of the class or the subclass used in the creation of an instance. When
used with the other key properties of this class, this property allows all instances of this
class and its subclasses to be uniquely identied.
DeviceID
An address or other identifying information used to uniquely name the LogicalDevice.
DisplayType
An integer enumeration describing the type of at panel display.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Passive Matrix LCD
• 3 = Active Matrix LCD
• 4 = Cholesteric LCD
• 5 = Field Emission Display
• 6 = Electro Luminescent Display
• 7 = Gas Plasma 8 = LED
ElementName
A user-friendly name for the object. This property allows each instance to dene a user-
friendly name in addition to its key properties, identity data, and description information.
NOTE: The Name property of ManagedSystemElement is also dened as a user-
friendly name. But, it is often subclassed to be a Key. It is not reasonable that the
same property can convey both identity and a user-friendly name, without
inconsistencies. Where Name exists and is not a Key (such as for instances of
LogicalDevice), the same information can be present in both the Name and
ElementName properties.
HorizontalResolution
The horizontal resolution in Pixels of the at panel.
MaxQuiesceTime
The use of this property has been deprecated. When evaluating the use of Quiesce, it was
determined that this single property is not adequate for describing when a device will
automatically exit a quiescent state. In fact, the most likely scenario for a device to exit a
quiescent state was determined to be based on the number of outstanding requests queued
rather than on a maximum time. This decision will be re-evaluated and repositioned later.
Deprecated description: Maximum time, in milliseconds, that a Device can run in a Quiesced
state. The state is dened in its Availability and Additional Availability properties, where
Quiesced is conveyed by the value 21. What occurs at the end of the time limit is device-
specic. The Device can unquiesce, can be oine, or can take other actions. A value of 0
indicates that a Device can remain quiesced indenitely.
ScanMode
The scan mode of a at panel indicating either single (value = 2) or dual scan 3.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Single Scan
• 3 = Dual Scan
SystemCreationClassName
The creation class name of the scoping system.
SystemName
The system name of the scoping system.
48 Dell Command | Monitor10.1.0 classes and properties