Reference Guide

Property Description
unicode indicates fully multi-lingual text support. A string BIOS Attribute with value of regex
is a regular expression and the CIM_BIOSString.ValueExpression is applied to values
represented and any value that is attempted to be set by invoking SetBIOSAttribute().
Possible values are:
• 0 = Unknown
• 2 = ASCII
• 3 = hex
• 4 = unicode
• 5 = regex .. = DMTF Reserved
• 65536..4294967295 = Vendor Reserved
DCIM_MemoryError
Property Description
DeviceCreationClassName
The scoping StorageExtent's CreationClassName.
DeviceID
The scoping StorageExtent's DeviceID.
ElementName
A user-friendly name for the object. This property allows each instance to dene a user-
friendly name in addition to its key properties, identity data, and description information.
NOTE: The Name property of ManagedSystemElement is also dened as a user-
friendly name. But, it is often subclassed to be a Key. It is not reasonable that the
same property can convey both identity and a user-friendly name, without
inconsistencies. Where Name exists and is not a Key (such as for instances of
LogicalDevice), the same information can be present in both the Name and
ElementName properties.
ErrorInfo
An integer enumeration describing the type of error that occurred most recently. For
example, single (value = 6) or double bit errors (7) can be specied using this property. The
values, 12 – 14, are undened in the CIM Schema since in DMI, they mix the semantics of
the type of error and whether it was correctable or not. The latter is indicated in the
property, CorrectableError.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = OK
• 3 = Bad Read
• 4 = Parity Error
• 5 = Single-Bit Error
• 6 = Double-Bit Error
• 7 = Multi-Bit Error
• 8 = Nibble Error
• 9 = Checksum Error
• 10 = CRC Error
• 32768 = DIMM Disabled via Spare Activation
StartingAddress
Species the address of the memory error. The type of error is described by the ErrorInfo
property. If the ErrorInfo property is equal to 3, OK, then this property has no meaning.
230 Dell Command | Monitor10.1.0 classes and properties